Women's magazine » Nail care » Design of nails with shellac with pastes and spangles: ideas of design with black, multi-colored and red color

Design of nails with shellac with pastes and spangles: ideas of design with black, multi-colored and red color

  While shellac manicure looks perfectly and remains on nails within several weeks, is at it and some shortcomings. It is more expensive, than other types of manicure even if you do it independently. It is explained by costs of purchase of an ultra-violet lamp for nail extension and special gel varnishes.

The design of nails with shellac has to be executed by the qualified master because it it is easy to spoil houses and, most likely, you will need some rounds of practice. Besides, this type of manicure not for those who wants to change manicure on a daily or weekly basis. Removal of shellac demands an atsetonovy bathtub which can weaken your nails if to do it too often.

 If you strongly intend to make manicure with shellac independently, here recommendations how to execute it everything in 10 minutes.

It will be necessary for you:

  • Base and finishing covering for shellac;
  • Shellac gel varnish on your color preference. You can also use usual nail varnish which will keep about 1,5 weeks;
  • Disinfectant for a nail surface;
  • UF-lamp;
  • Alcohol.

Stages of creation of design of nails with shellac:

Step 1: Use a disinfectant for removal of all pollution and fat from a nail surface.

Step 2: Apply a thin film of a basic covering, then place hands in the UF-lamp for 10 seconds.

Step 3: Apply a thin film color gel varnish. After that take nails in UF - "dryer" within 2 minutes.

Step 4: Repeat a step 3.

Step 5: Apply a thin film of a finishing covering and take hands in the UF-lamp within 2 minutes. After its polymerization wipe the wadded ball moistened in alcohol fingers to remove a sticky layer.

Voila! Your manicure is ready.

Design of nails with shellac with pastes and spangles: ideas of design with black, multi-colored and red colorHow to remove shellac:

  • Moisten cotton wool in acetone and place it on nails.
  • Wrap up a finger-tip and the cotton wool impregnated with acetone in a foil that the wadded tampon was in contact with a nail for a period of up to 10 minutes. ( It isn't necessary any more as acetone will evaporate).
  • Layers of shellac have to exfoliate quite easily. If it is necessary, use wooden a stick for a cuticle to clear surplus.

Manicure with shellac: ideas of design with a rabbit and patterns

For manicure with the stylized image of a rabbit it will be required to you:

  • Base and finishing covering for shellac.
  • Varnish gel light (for example mint color shellac), black and white flowers.
  • Dots (the tool for drawing points).
  • Disinfectant for a nail surface.
  • UF-lamp.

Step-by-step performance of idea of design shellac with a neyl-art in the form of a rabbit:

  1. Use a disinfectant for removal of all pollution and fat from a nail surface.
  2. Apply a thin film of a basic covering, then place hands in the UF-lamp for 10 seconds.
  3. Put a layer of a light varnish. Take nails in the UF-lamp within 2 minutes.
  4. Repeat a step 3.
  5. Put one big black point which has to close almost all tip of a nail. It will be a body of a rabbit.
  6. Over the first point put the second point, it is less. It will be the head of a rabbit.
  7. Use dots for creation of ears of a rabbit, "having dragged" a little varnish from the top point.
  8. Place nails in the UF-lamp and dry up within 2 minutes.
  9. Put a small white point in a lower body of a rabbit. It will be his tail. Dry up nails in the UF-lamp.
  10. Put the top layer and dry up within 2 minutes.

Such shellac can be used idea of design for creation of manicure for Easter.

With patterns it will be necessary for daily manicure for you:

  • Base and finishing covering for shellac.
  • Black varnish gel (for example Akzentz Luxio Gel in Noir).
  • Uf-gel Odyssey Nail Systems The One Gel Art II — Sterling.
  • Dots (the tool for drawing points).
  • Disinfectant for a nail surface.
  • UF-lamp.

Performance stages:

  1. Use a disinfectant for removal of all pollution and fat from a nail surface.
  2. Apply a thin film of a basic covering, then place hands in the UF-lamp for 10 seconds.
  3. Put a layer black a varnish gel. Dry up in the UF-lamp within 2 minutes.
  4. Apply a thin film of Odyssey Nail Systems The One Gel Art II — Sterling. You don't dry.
  5. Use dots for creation of helicoid patterns. Then dry up a nail by means of the UF-lamp within 2 minutes.
  6. Put the top layer and dry up within 2 minutes.

How to make shellac with black design

Here that is necessary for you to start work:

  • UF or LED lamp.
  • Gelish (Gelish) base, black gel varnish (for example, Harmony Gelish, color No. 01348 Black Shadow or Harmony Gelish,  color No. 01424 Welcome to the Masquerade) and finishing covering. These are 3 main subjects for creation of shellac of black design.
  • 99% isopropyl alcohol or a special cleaner for removal of a sticky layer. Usually in salon use Gelish Cleanser, observing all procedures of safety and sanitation. However, most likely, if you are engaged in creation of manicure in house conditions, you use available and inexpensive products. If this is so, is quite acceptable to use isopropyl alcohol as replacement to a professional tool.
  • Lint-free napkin. Usual cotton towels or tissues it isn't recommended.
  • Sunblock cream ( in case of use of the UF-lamp). If you use light-emitting diode, you can pass this stage.
  • Stick and oil for a cuticle.
  • Nail file on 180 units.
  • The buffer for nails.
  • Desk lamp or additional light. You will need good lighting to apply gel properly.

Design of nails with shellac with pastes and spangles: ideas of design with black, multi-colored and red color Take a desk lamp and be convinced that your hand is directly under its light during drawing a varnish. You have to be able to see accurately each nail under each possible corner.

Before work find a convenient, spacious place.

Remember that it is necessary to spend for creation of manicure , at least, half an hour therefore be convinced that you have enough place to warm up hands and feet and thus not to overturn gel.

Before beginning work, collect hair that they didn't climb in eyes, you descend to the bathroom, have a bite, drink soft drink and postpone phone. You  won't be able to use your hands anyway, irrespective of as far as you will "be careful". It also means that it is impossible to touch a face, hair , etc.

It is important to know

At creation of shellac of black design of nails extremely important to touch nothing! Dirt and fat can easily spoil manicure.

Remember that each layer of the gel applied on nails has to be thin. The dense layer won't allow gel to dry properly.

You have to dry each layer separately.

 Don't do all 10 nails at a time. It almost always leads to a casual touch to sticky gel on a nail of other hand or to the admission of a stage of performance of manicure.

Break work into 3 parts:

  1. 4 fingers on the left hand.
  2. 4 fingers on the right hand.
  3. 2 remained fingers.

Stages of putting shellac:

  1. For those who uses the UF-lamp: apply sunblock cream on hands. Those who use LED lamps, can pass this step.
  2. Cut off nails or file them to the necessary length and a form a file with granularity 180 grit.
  3. Use a stick for a cuticle carefully to remove it.
  4. Use the buffer softly to remove gloss from a nail. Pay special attention to a zone round a cuticle and try to process as it is possible closer to it. If you see any brilliant spots on a nail surface, slightly polish them. It is necessary for the best coupling of gel with a nail.
  5. Remove dust from a nail with the lint-free napkin impregnated with alcohol.
  6. Now you are ready to apply gel. If you need to make a break on something, now it is a high time to make it. As soon as you begin the following step,  you won't be able to stop until the latest step is executed. Your nails will be sticky, and each mote or down will destroy already almost ready manicure.
  7. Apply a basic covering gelish on 4 fingers of the left hand. Try not to concern a cuticle, otherwise the manicure will quickly exfoliate in this place. If it occurred, use an orange stick to clear a cuticle.
  8. Place 4 fingers under a lamp and take within 45 seconds. (Time will vary depending on lamp power, read the instruction).
  9. After an otverzhdeniye take away a hand from a lamp and put the first layer of a black gelish, beginning from free edge of a nail. Take fingers under the UF-lamp within 45 seconds. When you take away a hand from a lamp, gel will be sticky.
  10. Put the second layer of a gelish and again dry up it.
  11. Put the top layer, beginning from free edge. Be very careful and watch that the finishing covering covered all nail. Dry up the UF-lamp within 45 seconds.
  12. Use the napkin impregnated with alcohol to remove a sticky layer. If all of you is made correctly, your nails have to have a glossy appearance.
  13. Now time came to repeat all these steps for 4 fingers on other hand, and then for two thumbs.

We carry out shellac design with pastes in house conditions

Design of nails with shellac with pastes and spangles: ideas of design with black, multi-colored and red colorFor simple and, at the same time, original "striped" design shellac with pastes it will be necessary for you:

  • UF-lamp.
  • 99% isopropyl alcohol and lint-free napkin.
  • Shellac base.
  • Shellac of 4 different flowers. For an example it will be used cream, yellow, green and pink colors.
  • Pastes.
  • Toothpick.
  • Finishing covering.

Stages of performance of manicure:

  1.  By means of alcohol and a napkin wipe nails to remove dirt and fat from their surface.
  2. Apply a thin film of a basic covering and dry up in the UF-lamp of 45 seconds.
  3. Apply two thin films of shellac of cream color and dry up each layer within two minutes.
  4. Lower a tip of a flat oval brush in yellow shellac and carry out thin vertical strips on the right and left edges of a nail.
  5. Use green gel varnish to carry out a fat vertical strip near the left yellow strip (closely to it).
  6. Apply a thin film of the top covering and dry up within two minutes. Don't delete a sticky layer.
  7. Draw two thin pink strips on the right and left parties of a nail. One of them will be as if dividing border between yellow and green strips at the left, another — between cream and yellow on the right. Dry up within two minutes.
  8. On pink strips by means of a toothpick attach pastes in the form of "snake".
  9. Drip a small drop of a top sideways from pastes for fixing. Dry up nails in Uf-lampe of 10-15 seconds.
  10. Apply the top covering on nails, around and atop and dry up a paste within two minutes.
  11. Wipe a nail of 99% of isopropyl alcohol to remove a sticky layer.

Your shellac design with pastes is ready.

Shellac red marble: stages of creation of design

For creation of marble effect on nails it is enough to use a brush and a small amount of alcohol.

Also it will be necessary for you:

  • UF-lamp.
  • Alcohol.
  • Shellac base.
  • Shellac of light pink color.
  • Shellac of red color.
  • Shellac of white color.
  • Finishing covering.

Here is how to make red shellac design:

  1. Put a basic layer and dry up.
  2. Put two layers of pink shellac and you dry nails in the UF-lamp for 2 minutes (or less — depends on lamp power) after drawing each layer.
  3. Apply points of red and white color on nails, but  you don't dry.
  4. Lower a brush in alcohol and slightly "squeeze out" about edges of a small bottle that the brush wasn't too damp.
  5. Slowly apply a brush to points to create a type of marble. Clear a brush before processing of each nail.
  6. Dry up nails in the UF-lamp within 2 minutes.
  7. For end of shellac of red design put the top layer of shellac. Dry up within 2 minutes.
  8. Wipe nails means for removal of a sticky layer.

Design of shellac with spangles: galactic manicure

Design of nails with shellac with pastes and spangles: ideas of design with black, multi-colored and red color The space manicure looks beautifully and brightly on averages and long nails.

It perfectly will be suitable for an image of "vamp" or for addition of a dress in dark tones.

For its creation it will be required to you:

  • UF-lamp.
  • Shellac base.
  • Shellac of color asphalt (Asphalt).
  • Glitter holographic silvery with multigloss (microspangle).
  • Light glitter of Ultrafine Glitter.
  • Holographic glitter of a hexagonal form ( in the form of the correct hexagon) light green color.
  • Finishing covering shellac.

Follow these steps for creation of design of shellac with spangles:

  1. Put a basic covering shellac and take nails in the UF-lamp within 10 seconds.
  2. Apply a thin film of shellac of asphalt color.
  3. Dry up within two minutes.
  4. Repeat the second stage.
  5. Put microspangles for nails, concentrating them on the center of a nail and  on each side. The strip in the middle of a nail has to turn out.
  6. Below the front page put Ultrafine Glitter layer, going down to free edge of a nail.
  7. Apply a thin strip of a silvery glitter on free edge of a nail. It shouldn't be ideal, but can have vague similarity to the French manicure.
  8. Put hexagonal holographic spangles along the dividing line between Ultrafine Glitter and microspangles.
  9. Put a finishing covering. Take nails under the UF-lamp within two minutes.
  10. Use the lint-free napkin moistened in 99% isopropyl alcohol to remove a sticky layer. Your design of shellac with spangles is ready.